Huawei SmartLi-ESM-24020P1 - Page 20

Figure 1-11 Inserting the module
Step 7 When the outer handle is about to enter the door beam, assign the two persons
to release the outer handle, fasten the outer handle properly, and hold the side
bottom of the battery module to continue to insert the module slowly.
Figure 1-12 Continuing to insert the module
Step 8 Insert the module into the cabinet using the mounting ears on both sides. After
the module is in position, attach the mounting ears closely to the door beam, and
tighten the screws.
Figure 1-13 Attaching the mounting ears closely to the door beam
Step 9 If multiple battery modules need to be installed, perform Step 1–Step 8 in
sequence, and install a ller panel between battery modules at the upper and
lower layers.
SmartLi-ESM-24020P1
Quick Guide 1 Installation and Cable Connection
Issue 03 (2022-12-30) Copyright © Huawei Digital Power Technologies Co., Ltd. 14