SUN2000 (8KTL-28KTL)
User Manual
9 Inverter-Associated Operations
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Inverter-Associated Operations
This topic describes how to remove, pack, and dispose the SUN2000.
9.1 Removing the SUN2000
This topic describes how to remove the SUN2000.
Perform the following operations before removing the SUN2000:
1. Disconnect all cables from the SUN2000, including RS485 communications cables, DC
input power cables, AC output power cables, and protection ground (PGND) cables.
For details, see 8.1 Powering Off the SUN2000.
2. Optional: Open the anti-theft lock at the bottom of the SUN2000.
3. Remove the SUN2000 from the rear panel.
4. Remove the rear panel.
9.2 Packing the SUN2000
This topic describes how to pack the SUN2000.
If the original packing materials are available, put the SUN2000 inside them and then
seal them by using adhesive tape.
If the original packing materials are not available, put the SUN2000 inside a suitable
hard carton and seal them properly.
9.3 Disposing the SUN2000
This topic describes how to dispose the SUN2000.
If the SUN2000 service life expires, dispose the SUN2000 according to the local rules about
disposing electrical equipment waste, or return the SUN2000 to Huawei. Customers pay the
expenses for disposing the SUN2000.
To Next Page
Loading...
Need help?
General