SUN2000 (8KTL-28KTL)
User Manual
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Before removing the AC output connector, disconnect the circuit breaker between the
SUN2000 and the power grid.
Figure 5-15 Removing an AC output connector
5.3 Installing DC Input Power Cables
Connect the SUN2000 to PV arrays over DC input power cables
Prerequisites
PV modules generate electric energy when exposed to sunlight and can create an
electrical shock hazard. Therefore, when connecting DC input power cables, cover PV
modules by using opaque cloth.
Before performing electrical connections, ensure that voltages of the DC cables should
be within the safe voltage range, that is, lower than 60 V DC, and the DC SWITCH is
OFF. Otherwise, the high voltage may result in fatal danger.
Ensure that the following conditions are met. Otherwise, fire accident may occur.
To Next Page
Loading...
