Huawei SUN2000-23KTL - Setting Communications Parameters

SUN2000 (8KTL-28KTL)
User Manual
7 LCD
Issue 07 (2014-07-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
89
LCD
Operation Procedure
6. Enter a new password and press .
Increase or decrease the value by pressing
or . Switch between data bits by pressing
.
7. Enter the new password again and press
.
NOTE
Ensure that the confirm password is the same as the
new password. otherwise, an error message will be
displayed.
After password changing is complete, the
LCD displays a message, displaying that the
operation is successful.
----End
7.2.8 Setting Communications Parameters
This topic describes how to set RS485 communications parameters, including the address,
protocol, baud rate, and check mode.
Procedure

The following table describes the procedure for setting communications parameters. The
parameter values in the figures are for reference only.