Huawei SUN2000-50KTL-JPM0 - Page 56

SUN2000-(50KTL-JPM0, 50KTL-JPM1, 63KTL-JPM0)
User Manual
5 Electrical Connections
Issue 01 (2018-09-30)
Copyright © Huawei Technologies Co., Ltd.
50
Figure 5-23 Connecting cables to a terminal base
(1) RS485A IN
(2) RS485A OUT
(3) RS485B IN
(4) RS485B OUT
Step 4 Land the cables in the terminal block, and bond the shield layer to the ground point.
When connecting the shielded cable, crimp the OT terminal if required.
Figure 5-24 Connecting communications cables
Step 5 Bundle communications cables after connecting them.
Tie the communication cables with the cables on internal side of the maintenance compartment.