Huawei SUN2000-50KTL-JPM0 - Page 63

SUN2000-(50KTL-JPM0, 50KTL-JPM1, 63KTL-JPM0)
User Manual
6 Commissioning
Issue 01 (2018-09-30)
Copyright © Huawei Technologies Co., Ltd.
57
Procedure
Step 1 Turn on the AC switch between the SUN2000 and the power grid.
If you perform Step 2 before Step 1, the SUN2000 reports a fault about abnormal shutdown.
You can start the SUN2000 only after the fault is automatically rectified.
Step 2 Turn on the DC switch at the bottom of the SUN2000.
Step 3 Connect the SUN2000 to the mobile phone that runs SUN2000 app through a Bluetooth
module or USB data cable.

When the iOS is used, the app supports only Bluetooth connection.

The screenshots in this document correspond to SUN2000 app 2.2.00.031.
Figure 6-1 Bluetooth module connection
(A) SUN2000
(B) Bluetooth module
(C) Mobile phone
Purchase the Bluetooth module bundled with the SUN2000. A Bluetooth module purchased from any
other source may not support communication between the SUN2000 and the app.
Figure 6-2 Data cable connection
(A) SUN2000
(B) USB data cable
(C) Mobile phone