Figure 5-25 Connecting cables to a terminal base
(1) RS485A IN (2) RS485A OUT
(3) RS485B IN (4) RS485B OUT
Step 4 Land the cables in the terminal block, and bond the shield layer to the ground
point.
When connecting the shielded cable, crimp the OT terminal if required.
Figure 5-26 Connecting communications cables
Step 5 Bundle communications cables after connecting them.
SUN2000-(70KTL, 75KTL)-C1
User Manual 5 Electrical Connections
Issue 09 (2020-10-12) Copyright © Huawei Technologies Co., Ltd. 56
To Next Page
Loading...
