Alarm
ID
Alarm
Name
Alarm
Severity
Possible Cause Suggestion
2021 AFCI self-
check
failure
Major Cause ID = 1, 2
The AFCI self-check fails.
Turn o the AC output switch
and then the DC input
switches. After 5 minutes,
turn them on in the same
sequence. If the fault persists,
contact technical support.
2031 Phase
Wire
Short-
Circuited
to PE
Major Cause ID = 1
The impedance of the output
phase wire to PE is low or the
output phase wire is short-
circuited to PE.
Check the impedance of the
output phase wire to PE,
locate the position with lower
impedance, and rectify the
fault.
2032 Grid Loss Major Cause ID = 1
1. The power grid experiences an
outage.
2. The AC circuit is disconnected
or the AC switch is o.
1. Check the AC voltage.
2. Check whether the AC
circuit is disconnected or
the AC switch is o.
2033 Grid
Undervol
tage
Major Cause ID = 1
The grid voltage is below the
lower threshold or the
undervoltage duration exceeds
the time that triggers low voltage
ride-through (LVRT).
1. If the alarm occurs
occasionally, the power
grid may be abnormal
temporarily. The solar
inverter automatically
recovers after detecting
that the power grid
becomes normal.
2. If the alarm occurs
frequently, check whether
the power grid voltage is
within the acceptable
range. If not, contact the
local power operator. If
yes, log in to the mobile
app, SmartLogger, or
network management
system (NMS) to modify
the grid undervoltage
protection threshold with
the consent of the local
power operator.
3. If the fault persists for a
long time, check the AC
circuit breaker and AC
output power cable.
SUN2000-(100KTL, 110KTL, 115KTL)-M2
User Manual 8 Maintenance
Issue 02 (2022-06-30) Copyright © Huawei Technologies Co., Ltd. 95
To Next Page
Loading...
Need help?
General
