Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2. Tap Connect in the upper right corner. After establishing a connection with the
management system is successfully connected, the SUN2000 will report the SN and
installer registration code. If the connection fails, another connection attempt will start
after 10 seconds.
The installer registration code is generated by the SUN2000 automatically and is used for the installer to
register with the management system and manage the inverter.
Figure 7-51 Connection succeeded
4G Configuration
To set 4G access parameters, choose Comm config > 4G from the Operation console screen.
Figure 7-52 Setting 4G access parameters
Table 7-17 Description of 4G access parameters
To Next Page
Loading...
Need help?
General
