The initial password is 00000a. Use the initial password for first login. To ensure account security,
change the password immediately after login.
If you enter the passwords incorrectly for five consecutive times and the interval between
consecutive entries is less than 2 minutes, your account will be locked for 5 minutes.
Figure 7-12 Identity authentication
Step 2 If you log in successfully, the Quick setting or Home screen is displayed. (The Quick setting
screen is displayed only when the SUN2000 connects to the app for the first time or the
factory defaults of the SUN2000 are restored.)
Step 3 Perform quick setting.
Before setting the grid code, ensure that the DC side of the inverter is energized.
The Quick setting screen is displayed only when the SUN2000 connects to the app for the first time
or the factory defaults of the SUN2000 are restored.
If you do not follow the setting wizard, the Quick setting screen will still be displayed when you log
in next time.
To exit the setting, press the Back button on the mobile phone. To enter the Quick setting screen
again, choose Quick setting from the Home screen.
The Quick setting screen provides two setting modes. Select either of them based on site
requirements.
Method 1: quick setting
To Next Page
Loading...
Need help?
General
