Huawei TaiShan 200 Series - Page 87

● The default iBMC user account is Administrator.
● U-Boot is a piece of underlying software used to congure basic settings, for example,
initializing hardware devices and setting up memory space mapping, to prepare for
commissioning the OS.
● To ensure system security, change your initial password at your
rst login and change
the password periodically.
● A simple password is easy to crack, which makes the system vulnerable. You are advised
to use a password that meets complexity requirements or to enable the password
complexity check function.
● The password complexity check function is enabled by default.
You can change an iBMC user password on the iBMC WebUI or CLI. The following
describes how to change a user password on the iBMC WebUI. For details about
operations on the iBMC CLI, see the TaiShan Rack Server iBMC User Guide .
Changing the Initial Password of the Default iBMC User
Step 1 Log in to the iBMC WebUI and open the Local User page.
● If the iBMC version is earlier than V500, choose
Conguration > Local Users.
The page shown in Figure 5-38 is displayed.
Figure 5-38 Local Users page (earlier than iBMC V500)
● If the iBMC version is V500 or later, choose User & Security > Local Users.
The page shown in Figure 5-39 is displayed.
Figure 5-39 Local Users page (iBMC V500 or later)
Step 2 Modify user information.
● If the iBMC version is earlier than V500, locate the user and click . The page
shown in Figure 5-40 is displayed.
TaiShan 200 Server
User Guide (Model 2280) 5 Install and Congure
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 80