Figure 1-1 Wearing an ESD wrist strap
● When holding a board or a module with exposed circuit boards, hold its edge
without touching any components. Do not touch the components with bare
hands.
● Package boards or modules with ESD packaging materials before storing or
transporting them.
1.4 Environmental Requirements
Install the equipment in an area far away from liquids. Do not install it under
areas prone to condensation, such as under water pipes and air exhaust vents, or
areas prone to water leakage, such as air conditioner vents, ventilation vents, or
feeder windows of the equipment room. Ensure that no liquid enters the
equipment to prevent faults or short circuits.
General Requirements
● Do not install or run the equipment beyond the technical specications.
Otherwise, its performance and safety will be compromised.
● Do not install the equipment in environments with conductive metal scraps in
the air.
● Do not install the equipment in an environment with direct sunlight, dust,
volatile gases, infrared and other radiations, organic solvents, corrosive
materials, or salty air.
● Do not expose the equipment to
ammable or explosive gas or smoke. Do
not perform any operation on the equipment in such environments.
● Do not install, use, or operate outdoor equipment and cables (including but
not limited to moving equipment, operating equipment and cables, inserting
connectors to or removing connectors from signal ports connected to outdoor
facilities, working at heights, and performing outdoor installation) in harsh
weather conditions such as lightning, rain, snow, and level 6 or stronger wind.
UPSJZ-T-(1 kVA–3 kVA)
User Manual 1 Safety Information
2022-08-15 14
To Next Page
Loading...
Need help?
General