12
Scenario Connection Type
When you are unsure of the network connection you
subscribed to, you can select this mode that the device will
detect the network connection automatically.
Connect automatically
The account name and password are provided by your Internet
Service Provider (ISP).
Connect with user
account
No parameter is provided by your ISP. The IP address is
automatically assigned by the ISP.
Connect without user
account
3. Set WLAN parameters.
– If you selected Connect with user account，enter the parameters provided by your
Internet Service Provider (ISP) and click Next.
– If you selected Connect without user account, click Next.
4. Choose Home tab, click Set Up WLAN, set WLAN parameters, click Save.
Setting Dial-Up Connection Parameters
When the WS550 works in Bridge mode you need to perform this operation. Otherwise you do
not need to perform this operation.
Before setting dial-up connection parameters, verify that the WS550 is correctly connected to
your computer and you have the dial-up connection account name and password provided by
your Internet service provider (ISP). This section demonstrates how to set up a Point-to-Point
Protocol over Ethernet (PPPoE) connection on Windows.
On Windows 7
1. Choose Start > Control Panel > Network and Internet > Network and Sharing Center.
2. Under Change your networking settings, click Set up a new connection or network.
3. In the Set Up a Connection or Network window, select Connect to the Internet and click
Next.
If you reset Wi-Fi password, the login password to the web management page will remain
unchanged.
To Next Page
Loading...
