Introduction
OPERATION MANUAL Chapter 1
Unistat® V2.0.0en/09.06.16//15.09
Without an Ex p cabinet, the temperature control unit is NOT protected against explosion and
must NOT be installed or put into operation within an ATEX Zone. When operating the tempera-
ture control unit in conjunction with an Ex p cabinet, the information in the annex (section ATEX
operation) must be observed and followed. This annex is only provided for temperature control
units delivered with an Ex p cabinet. If this annex is missing, please immediately contact the Cus-
tomer Support of Peter Huber AG Kältemaschinenbau AG (the telephone number is provided on
page 95 section »Phone number and company address«).
The temperature control units Unistat tango (w/wl), Unistat 405(w), Unistat 410(w) und Unistat
705(w) do not have a plate heat exchanger.
Use with medical devices (e.g. in Vitro diagnostic procedure) or for direct foodstuff temperature
control is NOT permissible.
The temperature control unit must NOT be used for any purposes other than temperature control in
accordance with the operation manual.
The manufacturer accepts NO liability for damage caused by technical modifications to the temper-
ature control unit, improper handling or use of the temperature control unit if the operation manu-
al is not observed.
1.3 Responsible bodies and operators – Obligations and
requirements
1.3.1 Obligations of the responsible body
The operation manual is to be stored where it is easy to access in close proximity to the temperature
control unit. Only adequately qualified operators (e.g. chemists, CTA, physicists etc.) are permitted
to work with the temperature control unit. Operators must be trained before handling the tempera-
ture control unit. Check that the operators have read and understood the operation manual. Define
precise responsibilities of the operators. Personal protective equipment must be provided to the
operators.
▪ The responsible body must install a condensation water / thermofluid drip tray below the tem-
perature control unit.
▪ The responsible body must check whether national regulations require the mandatory installation
of a drain tray for the installation area of the temperature control unit/the entire system.
▪ Our temperature control unit complies with all applicable safety standards.
▪ Your system, which uses our temperature control unit, must be as safe.
▪ The responsible body must design the system so as to ensure it is safe.
▪ Huber is not responsible for the safety of your system. The responsible body is responsible for the
safety of the system.
▪ Whilst the temperature control unit provided by Huber meets all the applicable safety standards,
integration into a system may give rise to hazards that are characteristic of the other system’s de-
sign and beyond the control of Huber.
▪ It is the responsibility of the system integrator to ensure that the overall system, into which this
temperature control unit is integrated, is safe.
▪ The >Mains isolator< [36] (if present) may be provided with a facility to lock the main isolator in
the off position to facilitate safe system installation and maintenance of the temperature control
unit. It is the responsibility of the responsible body to develop any lock-out/tag-out procedure in
accordance with local regulations (e.g. CFR 1910.147 for the US).
1.3.1.1 Proper disposal of resources and consumables
Do comply with all national disposal regulations applicable for you. Contact your local waste man-
agement company for any questions concerning disposal.
To Next Page
Loading...
