Huber 705 - 1 Introduction

OPERATION MANUAL
Unistat® V2.0.0en/09.06.16//15.09
8
Table of contents
V2.0.0en/09.06.16//15.09
1 Introduction 14
1.1 Details on the declaration of conformity ....................................................... 14
1.2 Safety .......................................................................................................... 14
1.2.1 Symbols used for Safety Instructions .............................................................. 14
1.2.2 Proper operation ............................................................................................. 15
1.2.3 Reasonably foreseeable misuse ...................................................................... 15
1.3 Responsible bodies and operators – Obligations and requirements............... 16
1.3.1 Obligations of the responsible body ............................................................... 16
1.3.1.1 Proper disposal of resources and consumables ......................................... 16
1.3.1.2 Temperature control unit with natural refrigerants (NR) .......................... 17
1.3.1.3 Temperature control units with fluorinated greenhouse gases/refrigerants19
1.3.2 Requirements for operators ........................................................................... 19
1.3.3 Obligations of the operators ........................................................................... 20
1.4 General information ..................................................................................... 20
1.4.1 Description of workstation ............................................................................. 20
1.4.2 Safety devices to DIN 12876 ........................................................................... 20
1.4.3 Further protective devices .............................................................................. 21
1.4.3.1 Power interruption ..................................................................................... 21
1.4.3.2 Alarm functions .......................................................................................... 21
1.4.3.3 Warning messages ...................................................................................... 21
1.5 Exemplary illustrations of the cooling variants .............................................. 22
1.5.1 Air cooling ....................................................................................................... 22
1.5.2 Water cooling .................................................................................................. 22
1.5.3 Consequence of inadequate energy dissipation ............................................. 23
2 Commissioning 24
2.1 In-plant transport ......................................................................................... 24
2.1.1 Lifting and transporting the temperature control unit ................................... 24
2.1.1.1 Temperature control unit with lifting eyes ................................................ 24
2.1.1.2 Temperature control unit without lifting eyes ........................................... 25
2.1.2 Positioning the temperature control unit ....................................................... 25
2.1.2.1 Temperature control unit with casters ...................................................... 25
2.1.2.2 Temperature control unit without casters ................................................. 25
2.2 Transportation lock ...................................................................................... 25
2.2.1 Transportation lock Type A ............................................................................. 26
2.2.1.1 Releasing the transportation lock (operating position) .............................. 26
2.2.1.2 Tightening the transportation lock (transport position) ............................ 26
2.2.2 Transportation lock Type B ............................................................................. 26
2.2.2.1 Releasing the transportation lock (operating position) .............................. 26
2.2.2.2 Tightening the transportation lock (transport position) ............................ 26
2.3 Unpacking .................................................................................................... 27
2.4 Ambient conditions ...................................................................................... 27
2.4.1 EMC-specific notes .......................................................................................... 28
2.5 Installation conditions .................................................................................. 29
2.6 Temperature control unit for outdoor installation incl. winter operation ...... 29
2.7 Recommended temperature control and cooling water hoses ...................... 30
2.8 Wrench sizes and torques ............................................................................. 30