Huber tango - Sub-Category: Display Parameters

Setup mode
Chapter 4 OPERATION MANUAL
V2.0.0en/09.06.16//15.09 Unistat®
61
4.2.9.1.1 Sub-category: “Internal”
Enter the new values for “KP”, “Tn” and “Tv” here one after the other.
PROCEDURE
 Go to the “Categories Menu”.
 Tap on the category “Temperature Control”.
 Tap on the category “TAC/Manual”.
 Tap on the sub-category “Configuration manual”.
 Tap on the sub-category “Change parameters”.
 Tap on the sub-category “Internal”.
 Enter the new “KP” value using the number keypad that appears.
 Confirm your entry by tapping on “OK”.
 Enter the new “Tn” value using the number keypad that appears.
 Confirm your entry by tapping on “OK”.
 Enter the new “Tv” value using the number keypad that appears.
 Confirm your entry by tapping on “OK”.
4.2.9.1.2 Sub-category: “Jacket”
Enter the new value for “KP” here.
PROCEDURE
 Go to the “Categories Menu”.
 Tap on the category “Temperature Control”.
 Tap on the category “TAC/Manual”.
 Tap on the sub-category “Configuration manual”.
 Tap on the sub-category “Change parameters”.
 Tap on the sub-category “Jacket”.
 Enter the new “KP” value using the number keypad that appears.
 Confirm your entry by tapping on “OK”.
 Read the message and confirm it by tapping on “OK”.
4.2.9.1.3 Sub-category: “Process”
Enter the new values for “KP”, “Tn” and “Tv” here one after the other.
PROCEDURE
 Go to the “Categories Menu”.
 Tap on the category “Temperature Control”.
 Tap on the category “TAC/Manual”.
 Tap on the sub-category “Configuration manual”.
 Tap on the sub-category “Change parameters”.
 Tap on the sub-category “Process”.
 Enter the new “KP” value using the number keypad that appears.
 Confirm your entry by tapping on “OK”.
 Enter the new “Tn” value using the number keypad that appears.
 Confirm your entry by tapping on “OK”.
 Enter the new “Tv” value using the number keypad that appears.
 Confirm your entry by tapping on “OK”.
4.2.9.2 Sub-category: “Display parameters”
In this function, the set manual parameters are displayed.
PROCEDURE
 Go to the “Categories Menu”.
 Tap on the category “Temperature Control”.
 Tap on the category “TAC/Manual”.