Huber tango - Sub-Category: Control Structure; 4.2.10 Sub-Category: Reset Parameters; Sub-Category: Display Parameters

Setup mode
OPERATION MANUAL Chapter 4
Unistat® V2.0.0en/09.06.16//15.09
62
 Tap on the sub-category “Configuration manual”.
 Tap on the sub-category “Display parameters”.
 Tap on “OK” after you have read/checked the parameters.
4.2.9.3 Sub-category: “Control structure”
With this function, you have two different control structures available.
„Huber PID controller“: Default setting
“Classic PID controller”: This setting is used by the service engineers of Peter Huber Kältemaschi-
nenbau AG exclusively for service purposes.
PROCEDURE
 Go to the “Categories Menu”.
 Tap on the category “Temperature Control”.
 Tap on the category “TAC/Manual”.
 Tap on the sub-category “Configuration manual”.
 Tap on the sub-category “control structure”.
 Choose between the dialogue entries “Huber PID controller” and “Classic PID controller”.
 Confirm your choice by tapping on “OK”.
4.2.10 Sub-category: “Reset parameters”
With this function, you can reset the control parameters to the factory setting.
PROCEDURE
 Go to the “Categories Menu”.
 Tap on the category “Temperature Control”.
 Tap on the category “TAC/Manual”.
 Tap on the sub-category “Reset parameters”.
 Read the message and confirm it by tapping on “Yes”. The control parameters are reset/deleted.
The temperature control unit can only be operated again after a complete restart.
 To do so, switch the temperature control unit off and back on again. The parameters have been
reset.
4.2.11 Sub-category: “Display parameters”
In this function, the set parameters are displayed. Depending on the previous setting, these will be
the “Automatic control parameters” or the “Manual control parameters”.
PROCEDURE
 Go to the “Categories Menu”.
 Tap on the category “Temperature Control”.
 Tap on the category “TAC/Manual”.
 Tap on the sub-category “Display parameters”.
 Tap on “OK” after you have read/checked the parameters.