12Trolling Motor Mount
Connecting the Landscape Mode Mount to the Transducer
The ratchets are keyed.
5. Secure the transducer to the Landscape Mode mount with one of the included
lock washers and 1/4-28 screws, using the provided hex bit. Hand tighten the
screw until the lock washer is fully compressed (see the illustration Compressing
the Lock Washer), and then tighten an additional 1/4 turn. Hand tighten only!
CAUTION
The screw and lock washer MUST be fully tightened. Failure to do so may result in the
transducer detaching from the Landscape Mode mount in the water.
6. Rotate the MEGA Live 2 transducer around the shaft until it is parallel with the
lower unit of the trolling motor (see Aligning the Transducer). This ensures the
transducer is pointing in the same direction as the trolling motor.
To Next Page
Loading...
