23 MEGA Live Installation
10. Reinstall the Motor Stabilizer
1. If you removed your motor stabilizer prior to installing your Mega Live, reinstall
it now through the MEGA Live plate (see the illustration Reinstalling the
Motor Stabilizer) using the provided 5/16" screws with locking washers. It
may be necessary to shorten your motor stabilizer. See the installation guide
that was included with your trolling motor or visit www.minnkotamotors.com
for more information.
NOTE: A trolling motor stabilizer (
included with each Minn Kota Ultrex trolling
motor or available as a separately purchased accessory
) is required to support your
MEGA Live Targetlock. It must be installed before taking your MEGA Live on the
water.
Reinstalling the Motor Stabilizer
To Next Page
Loading...
