33 MEGA 360 Installation
5. Use an Allen wrench (not included) to tighten the hardware just enough to keep
the collar assembled.
6. Slide the collar up to the base of the BowGuard.
7. Use an Allen wrench (not included) to fully tighten the socket bolts until they
are secure. Hand-tighten only!
Details: Tighten the socket bolts and collar clamp hardware evenly on both
sides of the clamp until you feel them start to compress and secure, and then
tighten each bolt an additional 1/4 to 1/2 turn.
WARNING! The socket bolts must be tightened completely to prevent the trolling
motor from potentially damaging the pod. Hand-tighten only!
To Next Page
Loading...
