INSTALLATION
6
Mount the Brackets
■ Drill the screw holes using a
3
/
32
" drill bit.
Important: Use drywall anchors when
mounting into drywall.
■ Attach the installation brackets using the
screwsprovided.
Important: For proper operation, the
SofTrak
™
headrail must be mounted level.
Use a laser level to check that the installation
brackets are level and aligned. Shim the
brackets if necessary. The brackets may also
need to be shimmed if the mounting surface
is heavilytextured.
To Shim the Brackets:
■ Snap off the top of the shim for use with inside/ceiling mount
brackets.
■ Use the shims, as needed, between the mounting
surface and the inside/ceiling mount brackets.
Use a laser level as reference.
■ To make further adjustments, you may add
or remove shims by loosening the installation
bracket screws.
Proceed to “Install the SofTrak Headrail” on page13.
Level and Aligned
Snap Off
Shim
Loosen
screws
to add or
remove shims.
To Next Page
Loading...
Need help?
General