OPERATION
9
Problem Solution
The front fabric appears
to cling to the back fabric.
Lightly apply a static spray for home furnishings. Follow the ■
manufacturer's directions.
Allow the shade to dry in the fully lowered position. ■
If necessary, reapply the static spray each time the shade is ■
professionally cleaned.
Vignette
®
Top-Down/
Bottom-Up Shades Only:
Shade midrail appears
uneven.
Gently lift the lower side of the midrail until the shade ■
appears level.
The shade will not snap
into the installation
brackets.
Check that the installation brackets are aligned and level. ■
The window may be out of square. To check if the ➤
window is square, measure the diagonals.
Level the headrail by shimming the installation brackets, ➤
if necessary.
Check that the headrail is correctly inserted into the ■
installation brackets.
The universal cord
tensioner has climbed to
the headrail.
Pull down on the spring to relieve tension and pull the ■
universal cord tensioner to the bottom of the cord loop.
Properly mount the cord tensioner. See Universal Cord
Tensioner Installation Instructions in the kit included with
your shade.
The universal cord
tensioner grabs onto the
cord upon operation.
Check that the universal cord tensioner is mounted properly. ■
Reinstall, if necessary. Properly mount the cord tensioner.
See the Universal Cord Tensioner Installation Instructions
that came with your Cord Tensioner Kit.
To Next Page
Loading...
Need help?
General
