OPERATION
8
Operate The Shade
Pull the front cord of the cord loop to lower the ■
shade from the top. Continue to pull until the
shade is fully lowered and rotated back toward
the window.
Pull the rear cord of the cord loop to raise the ■
shade.
Continue to pull the rear cord to raise the shade ■
into the headrail.
Top-Down/Bottom Up Shades Only. ■ With the
bottom of the shade fully lowered, continue to
pull the front cord to lower the top of the fabric.
The fabric loops will stack at the bottom. On an
inside mount, the fabric loops may rest on the
window sill.
Lower
Raise
Troubleshooting
Problem Solution
The shade is hard to raise
or lower, or will not raise
or lower.
Check that the cord tensioner is mounted correctly. See ■
Universal Cord Tensioner Installation Instructions in the kit
included with your shade.
Check that the headrail and installation brackets are level ■
and aligned in the window.
The window may be out of square. To check if the ➤
window is square, measure the diagonals.
Level the headrail by shimming the installation brackets, ➤
if necessary.
Make sure the fabric is not caught in the installation bracket. ■
If the bottom rail is pulled inside the headrail, gently pull it ■
out by hand.
Check that cord loops are not pinched or tangled. ■
If hold-down brackets are used, make sure they have been ■
released before operating the shade.
To Next Page
Loading...
Need help?
General
