Hunter Douglas Vignette - Attach The Hold-Down Brackets (Optional); Attach The Universal Cord Tensioner (UCT)

INSTALLATION
7
Attach The Hold-Down Brackets (Optional)
Hold-down brackets may be used with outside mount shades only.
With the shade fully lowered, insert the pin on the ■
hold-down bracket into the hole on the bottom rail
end cap.
Mark the hole locations on the mounting surface. ■
Center the hold-down brackets over the mounting ■
hole locations and check their alignment. Attach using
two screws.
IMPORTANT: Disconnect the bottom rail from the hold-
down brackets to raise the shade.
Attach The Universal Cord Tensioner (UCT)
Before doing anything, you must fi rst slide the cord
tensioner to the bottom of the cord loop.
Insert a small screwdriver, punch, or awl through the ■
screw hole at the bottom of the cord tensioner.
Move the screw hole down to the indicator line to release ■
the safety mechanism.
Slide the cord tensioner down to the bottom of the ■
cord loop.
WARNING: It is imperative that the cord tensioner be properly secured to the wall
or window frame to reduce children’s access to the cord loop. Young children can
strangle in cord loops. They can also wrap cords around their necks and strangle.
CAUTION: The shading will not operate properly unless the cord tensioner is
secured. A cord tensioner installation kit has been included with your shading.
Follow the instructions in the kit to correctly secure the cord tensioner.
Indicator
Line
Universal
Cord
Tensioner