Hunter Douglas Vignette - Installation; Mount The Installation Brackets - Inside Mount

INSTALLATION
4
Mount The Installation Brackets — Inside Mount
Use pliers to break off and discard the tab of each bracket. ■
Measure in 3" from each jamb for bracket location. ■
If more than two installation brackets came with your order, ■
space additional bracket(s) on studs, evenly between the two end
brackets.
Mark the location of the screw holes by centering ■
the brackets on the previously made marks.
Minimum mounting depth for bracket attachment ➤
is 1". Fully recessed mounting depth is 3
7
/
8
".
Use a ■
3
∕
32
" drill bit to drill holes for the screws.
IMPORTANT: If you are fastening the installation
brackets to drywall, be sure to use wall anchors and
follow the instructions provided with the anchors.
(Anchors not provided.)
Use a level to check that the mounting surface is level. Shim the brackets if necessary. ■
(Shims not provided.)
Use the hex head screws provided to fasten the installation brackets to the mounting ■
surface.
IMPORTANT: The front edges of the installation brackets must be level and aligned to
each other.
Remove
Tab
3" Space Evenly Space Evenly
3"
3"
Minimum Depth
Required is 1"
Fully Recessed
Depth is 3
7
/8"