28
Selecting Interval Watering
This feature is convenient if you want to have a more consistent
watering schedule without having to worry about the day of the
week or the date. The interval you select is the amount of days
between watering including the watering day.
1. Turn the dial to the WATER DAYS position. The water drop
above Monday should be flashing.
2. Press the → button until EVEN is flashing, then press the →
button one more time. The display will change to the interval
mode and the Interval Day number will be flashing.
3. Press the + button. The display will now show two numbers:
the interval, and the days remaining in the interval.
4. The number of days between waterings, or the interval, will
be flashing. Use the + and - buttons to select the number of
days desired between waterings.
5. Press the→button. The days remaining in the interval are
now flashing. Use the + and - buttons to select the number
of days until the next desired watering. One day remaining
means it will water the next day.
SETTING A WATERING SCHEDULE CONTINUED
NOTE: If any days are selected as non-
water days at the bottom of the display,
the Interval Day watering will exclude
those days. For example, if the Interval
Days are set at and Monday is a non-
water day, the controller will water every
th day, but never on a Monday. If the
interval water day falls on a Monday and
Monday is a non-water day, the program
would not water for more days resulting
in no irrigation for days total.
To Next Page
Loading...
Need help?
General
