35
Programmable Sensor Override
The Pro-C allows the user to program the controller so that the
sensor disables watering on only desired stations. For example,
patio gardens that have pots under overhangs and roofs may
not receive water when it rains and will continue to need to be
watered during periods of rain. To program sensor override:
1. Turn the dial to the RUN position.
2. Press and hold the- button while turning the dial
to the START TIMES position.
3. Release the - button. The display will show the station
number, the SENSOR icon, and ON will be flashing.
4. Press the + or - button to enable or disable the sensor
for the station shown.
ON = Sensor enabled (will suspend irrigation)
OFF = Sensor disabled (will allow watering)
5. Use the ←or → buttons to scroll to the next station that you
would like to program the sensor override.
A station that is running in the sensor override mode will display
the word “SENSOR” and flash the icon.
HIDDEN FEATURES CONTINUED
NOTE: The controller default is for the
sensor to disable watering on all zones
when rain occurs.
To Next Page
Loading...
Need help?
General
