33
ADVANCED FEATURES
Set Pump/Master Valve Operation
The default is for all stations to have
the master valve/pump start circuit ON.
The master valve/pump start can be set
ON or OFF by station, regardless of
which program the station is assigned.
To program pump operation:
1. Turn the dial to the PUMP position.
2. Press the + or - buttons to toggle the master valve/pump start
ON or OFF for the specific station.
3. Press the→button to advance to the next station.
4. Repeat steps 2 and 3 for all necessary stations.
Programmable Rain O
This feature permits the user to stop all
programmed waterings for a designated
period from 1 to 31 days. At the end of the
programmable rain off period, the controller
will resume normal automatic operation.
1. Turn the dial to the SYSTEM OFF
position.
2. Press the + button and a 1 will be
displayed and the DAYS LEFT icon
will illuminate.
3. Press + as many times as needed to set the number of days off
desired (up to 31).
4. Turn the dial back to the RUN position, at
which time, OFF, a number and the DAYS icon
all remain on.
5. Leave the dial in the RUN position.
The days off remaining will decrease at
midnight of each day. When it goes to
zero, the display will show the normal
time of day and normal irrigation will
resume at the next scheduled start time.
Setting Specic Day(s) O
Programming a No Water Day(s) is useful to inhibit watering on
mowing days, etc. For instance, if you always mow the lawn on
Saturdays, you would designate Saturday as a No Water Day so
you are not mowing wet grass.
1. Turn the dial to the WATER DAYS position.
2. Enter an interval watering schedule as
described on page 28.
3. Press the → button once. MON will be flashing.
4. Use the → button until the cursor is at
the day of the week you wish to set as
a No Water Day.
5. Press the - button to set this day as a
no water day. The will illuminate over this day.
6. Repeat steps 4 and 5 until all desired event day(s) are off.
EVEN
-
To Next Page
Loading...
Need help?
General
