15
CONNECTING A HUNTER “CLIK” WEATHER SENSOR NOT INCLUDED
A Hunter weather sensor or other micro-switch-type weather
sensors can be connected to the Pro-C. The purpose of this
sensor is to stop automatic watering when weather conditions
dictate.
1. Remove the metal jumper plate that is attached across
the two SEN terminals inside the controller.
2. Connect one wire to one SEN
terminal, and the other wire
to the other SEN terminal.
When the weather sensor
has deactivated automatic
watering, “OFF” will appear
on the display.
To Next Page
Loading...
Need help?
General
