32
USING THE PROC TO OPERATE OUTDOOR LIGHTING OPTIONAL
Creating a Lighting Program
1. Turn the dial to the START TIMES position.
2. Press and hold the PRG button for 6 seconds and observe the
A, B, C programs moving.
3. L1 and a flashing “OFF” will appear, and the controller is ready
to designate lighting programs.
4. Add a start time to lighting program L1 by pressing the + and -
buttons until the correct time is shown. Up to four start times
can be assigned to L1.
5. Turn the dial to the RUN TIMES position. Press the PRG
button repeatedly until L1 is shown. Use the + and - buttons to
add a run time to lighting program L1.
When using a second or third lighting transformer, repeat the
same steps above after connecting the additional PXSync boxes,
adding start and run times accordingly.
You do not need to program days of the week for lighting
programs. They can run every day according to the
programmed start and run times.
Example of screen upon entering
Lighting program can be activated
Example of ashing screen while holding down on PRG button
To Next Page
Loading...
Need help?
General
