30
OPTIONS FOR RUNNING YOUR IRRIGATION SYSTEM CONTINUED
One - Touch Manual Start and Advance
You can also activate a program to water without using the dial.
1. With the dial in the RUN position, hold down the → button for
2 seconds.
2. This feature automatically defaults to program A. You can
select program B, or C by pressing the PRG program.
3. The station number will flash. Press the ← or → button to
scroll through the stations and use the + and - buttons to
adjust the station run times. (If no buttons are pressed during
step 2 or 3, the controller will automatically begin program A.)
4. Press the →button to scroll to the desired station to start
with. After a 2-second pause, the program will begin.
This feature is great for a quick cycle when extra watering is
needed or if you would like to scroll through the stations to inspect
your system.
To Next Page
Loading...
