13
You have the ability to adjust the amount of time
that a station will run once it has been turned on by
your SRR System. This does not affect the run time
programmed into your controller. This adjustment is
made using the transmitter as described below.
To change the Remote Activated Station Run Time
follow the steps below:
1. If the unit is off (no display), power the
transmitter up by pressing or any of the buttons
for at least 1 second and then releasing the
button. The transmitter will first illuminate the
entire display for 1 second then display the
active station.
2. Press the and buttons simultaneously,
until the word “RUN TIME” along with the
current Run Time is displayed (default is 10
minutes). The display will be blinking at this
point. If more than 5 seconds go by without a
button being pressed, the Transmitter will revert
back to displaying the active station.
NOTE: Black buttons indicate what
is to be pushed.
CHANGING THE REMOTE ACTIVATED STATION RUN TIME ......
3. Use the and buttons to change the Run
Time to any of the 8 settings ranging from 1
to 30 minutes. Then do not touch any of the
buttons for 5 seconds and the display will stop
blinking, and return back to the active station.
To Next Page
Loading...
