23
TROUBLESHOOTING GUIDE .............................................................
PROBLEM CAUSES SOLUTIONS
Transmitter display is blank. Transmitter is off. Press any button for 1 second.
Battery is dead. Replace battery.
Can’t access all the desired Maximum station number is set wrong. See “Changing the Maximum Station
stationson the Transmitter. Number” on page 12.
Receiver doesn’t beep two times SmartPort
®
is not connected properly. Recheck SmartPort wiring.
after plugging it in. Controller has no power. Check controller power.
Receiver beeps twice after Receiver and Transmitter address Relearn address at receiver.
plugging it in, but won’t respond don’t match.
to Transmitter.
Transmitter display stays on. Transmitter will turn off automatically. Wait approximately 5 minutes without
pressing any buttons. Transmitter will
“fall asleep.”
“ERR” message in controller SmartPort wiring leads have been Replace lengthened wire with shielded
display when controller is in the extended and are receiving radio cable to prohibit radio interference. Use
run position. interference. Hunter SRR-SCWH. See “Extending
Wiring on SmartPort Harness” on page 7.
Receiver does not receive signal Mismatch of addresses in transmitter Reset address of receiver. See page 14.
from remote held at close range. and receiver.
Remote has short range (i.e. less Check for interference causes. See “Maximizing Operating Range”
than 100 feet). on page 7.
To Next Page
Loading...
