Hunter SRR - Activating a Station with the SRR Remote Control System

20
The SRR System will allow you to remotely turn on
and off any station on your SRC, ICC, or future Hunter
controller with the press of a button. Once on, the
station will run for the run time you have designated
in the remote. To remotely activate a station or
program follow the steps below:
1. Plug the Receiver into a SmartPort
®
that is
connected to a powered controller and wait for
two beeps indicating that the Receiver
is ready.
2. If your Transmitter is not on (no display), press
any button for at least one second and release.
The Transmitter will first illuminate the entire
display, then display the active station.
3. Use the
and buttons to display the station
or program you would like to start.
4. Press the
button to start the station or
program. The Transmitter will display the word
“TRANSMIT” and the letters “On”. Both will
ACTIVATING A STATION WITH THE SRR REMOTE
CONTROL SYSTEM .............................................................................
flash for about 4 seconds indicating that it is
sending the command to the receiver. If you are
near the Receiver, you will here it beep 2 times.
This indicates that the Receiver has received the
command.
5. Press the
button to turn off any station that
is on. The display will read “TRANSMIT” and the
letters “Of”. Both will flash for about 4 seconds,
and the Receiver will beep again twice. The SRR
System is designed to turn on one station at a
time (unless you activate a program). Therefore,
turning a station on while another station is
operating will cause the operating station to
turn off.
NOTE: The SRR remote can activate
any station on the controller whether
the controller dial is in the “SYSTEM
OFF”, “RUN” or “RUN/BYPASS SENSOR”
modes. If a sensor device has been
wired to the controller, the SRR
remote will NOT override the sensor
for manual operation.