14
Both the SRR Transmitter and Receiver have an
“address” that they use when communicating. If the
addresses do not match, the receiver will ignore the
transmission.
Your SRR comes from the factory with both the
Transmitter and the Receiver address set to 0. You
may change the address to any value from 0 through
127 for added security. Note that if you change the
Transmitter address, the Receiver must “learn” the
new address as described in “Preparing the Receiver
for Use” section.
To change the Transmitter address follow the
steps below:
1. If the unit is off (no display), power the
Transmitter up by pressing any of the buttons for
at least 1 second then releasing the button. The
Transmitter will first illuminate the entire display
for 1 second then display the active station.
CHANGING THE TRANSMITTER ADDRESS ..................................
2. Press the and buttons simultaneously,
until the word “RUN TIME” along with the
current Station Run Time is displayed. The
display will be blinking at this point.
3. While the display is blinking and showing the
current Run Time, Press the button. The word
“ADDRESS” will now illuminate and the current
address will be blinking. Note that if more than
5 seconds go by without a button being pressed,
the Transmitter will revert back to displaying the
active station.
4. Use the
and buttons to change the address
to any value between 0 and 127. Then do not
touch any of the buttons for 5 seconds and the
display will stop blinking, and return back to the
active station.
To Next Page
Loading...
