Hunter TCX56 - 4.2 Maintenance and Replacement Parts

Operation Instructions for TCX56/57 Tire Charger
62
Maintenance Schedule Perform the Following Maintenance
Daily
Drain condensation from pressure regulator
reservoir by pressing in on the tting located on
the bottom of the regulator.
Check for worn or damaged rubber and nylon
components that should be replaced to prevent
damage from occurring. Replace worn parts
as needed (tool supports, rubber pads, lever
protector sleeve and mount/demount head).
Clean all areas that contact rims or tires to
preventpossible scratching to rim.
Weekly
Clean tire changer with shop towels or a vacuum
cleaner. Do not clean with or use compressed
air, which can blast dirt between moving parts.
Do not use cleaning solvents to clean pressure
regulator/oiler.
Periodically
Rell the pressure regulator/oiler using only
Hunter Lubri-Oil, 148-133-2, as needed.
Petroleum-based oils should never be used in
the oiler and may void all warranties.
Adjust the oiler to release one drop of oil every
three rotations of the clamping table by adjusting
the screw on top.
Check for loose bolts and tighten per
specications.
4.2 Maintenance and Replacement Parts
NAME NUMBER
Safety Goggles 179-15-2
Brush RP6-1506
Mounting Paste RP6-3784
Polymer Mount/Demount Head RP11-3314813
Hand Held Bead Lever - straight RP11-3009516
Bead Lever Protector Sleeve (Std) (4) RP11-8-11400098
Jaw Protection Kit (2 sets - 8 covers) RP11-8-11400085
TCX56
Steel Head Inserts (10 sets - 20 covers)
RP11-8-11400096
TCX57
Mount/demount Protector Kit consisting of:
10 demounting protectors
5 mounting protectors
15 protector screws
RP11-8-11400293