Operation Instructions for TCX56/57 Tire Charger
38
DISC
REPOSITIONED
AND LOCKED
IN PLACE
With the tire in position, press the wheel rotation pedal to rotate the wheel
clockwise and demount the bottom bead.
2.4 Alternate Procedure
Using the Bead Lever
Clean the mount/demount head to remove dirt and debris before demounting the tire
from the rim.
NOTICE
Press the wheel rotation pedal until the valve location is in the one o’clock
position.
Position the mount/demount head against the outer edge of the upper rim lip.
Slide the mount/demount head in or out along the upper rail and lower the head into position.
Push the button on handle to lock head into position.
A plastic protector sleeve may be installed on the bead lever tool to aid in rim protection.
Position the bead lever between the demounting lip of the head and bead of tire. The
demonting lip is on the right side of the head.
Push down on the tire sidewall 180 degrees from the mount/demount head to slip the
bead into the drop center of rim.
To Next Page
Loading...
