Hunter TCX56 - TCX57 - LEVERLESS MOUNTING HEAD; Top Bead Demounting

Operation Instructions for TCX56/57 Tire Charger
31
TCX57 - LEVERLESS MOUNTING HEAD
Using leverless mounting head follow always this indications
NOTICE
CHECK MOUNT HEAD
CALIBRATION MONTHLY
ALWAYS
LUBRICATE
TIRE
LUBE
1,5 mm
2 mm
Cod. 4-113552
ALWAYS MOUNT WITH BEAD
OVER BACK OF MOUNT HEAD
USE ASSIST FEATURES
TO PREVENT DAMAGE
Top Bead Demounting
Position the mount/demount head against the outer edge of the upper rim lip. The plastic
surfaces should contact the rim lip.
Slide the mount/demount head in or out along the upper rail and lower the head into position.
Lock the lever. Adjust the diameter knob for correct side spacing. The mount / demount head
will automatically build in the proper vertical spacing.
NOTICE
Always make sure the wheel is being rotated while inserting the automatic lever.
Locate an area with a gap between the tire and wheel.
Press the wheel rotation pedal
to rotate the wheel clockwise. While rotating, insert
the automatic lever into the rim / tire assembly using the control switch.
NOTICE
Always ensure that the automatic lever is inserted in a gap between the rim and the
tire. If the automatic lever is inserted without a gap, tire damage can occur.