Hunter TCX56 - Specific Precautions;Power Source; Equipment installation and service

Operation Instructions for TCX56/57 Tire Charger
16
• HAZARDOUS VOLTAGE
• Turn of and lock out system power before
servicing.
• Contact may cause electric shock or death
DANGER
Make sure that the electrical supply circuit and the appropriate receptacle is installed with
proper grounding.
To prevent the possibility of electrical shock injury or damage to the equipment when
servicing the TCX56/57, power must be disconnected by removing the power cord from the
electrical power outlet.
After servicing, be sure the TCX56/57 ON/OFF switch is in the “O” (off) position before
plugging the power cord into the electrical power outlet.
Specific Precautions/Power Source
The TCX56/57 is equipped with motoinverter, (220VAC / 1PH / 50-60Hz) and standard plug
220V L6-20P plug.
This machine must be connected to a 20 amp branch circuit. Please refer all power source
issues to a certied electrician.
WARNING
A protective ground connection, through the grounding conductor in the power cord,
is essential for safe operation. Use only a power cord that is in good condition.
Equipment installation and service
A factory-authorized representative should perform installation.
This equipment contains no user serviceable parts. All repairs must be referred to a qualied
Hunter Service Representative