Hunter TCX56 - Precautionary Notes

Operation Instructions for TCX56/57 Tire Charger
34
Some of the more difcult tires may not allow for proper insertion of the automatic bead lever
because not enough of a gap can be created between the tire and the rim edge.
NOT ENOUGH GAP
BETWEEN TIRE AND
RIM EDGE
If this is the case, reposition the upper BPS disc as shown below. Lower the upper BPS
disc and push down to create a gap between the tire and the rim edge (A), then insert the
automatic bead lever (B).
(A) PUSH
DOWN AT THIS
POINT
(B) INSERT
AUTOMATIC
BEAD LEVER
Raise the BPS disc, and then rotate .
Precautionary Notes
NOTICE
When basic procedures are NOT followed, sharp angled wheel flanges increase
potential damage to tires during mounting. Be sure the mounting head is placed on
the rim with sufficient gap between the bead and bead seat. If the tire is incorrectly
pushed onto the rim by the side of the mounting head, it may become “trapped” and
increases mounting stress to the tire bead.
Insufcient lubrication and failure to place tire into drop center during mounting may also
cause the mount/demount head to fail prematurely.