Operation Instructions for TCX56/57 Tire Charger
17
Equipment specification
Electrical
Voltage: 220 VAC, 1 phase, 50-60 Hz, includes NEMA L6-20P
Amperage: 20 amperes
Air
Air Pressure Requirements: 115-175 PSI (7.9-12.0 bar)
Approximate Air
Consumption:
at 8 bar = 6 Lt/s • 0.2118 Ft3/s • 12,70 CFM (ft3/min)
at 10 bar = 7,76 Lt/s • 0.2471 Ft3/s • 14,82 CFM (ft3/min)
Mechanical
Clamping System Rotating
Speed:
CW – 7 rpm and 17 rpm
CCW – 7rpm
Max. Tire Diameter: 43.3 in. w/BPS
Max Bead Roller Opening
Width:
15 in.
Diameter Range: 10-30
Explanations of symbols
These symbols may appear on the equipment.
Alternating current.
Earth ground terminal.
Protective conductor terminal.
Risk of electrical shock.
1.3.b. Air Pressures
The machine is equipped with an internal pressure limiting valve to minimize the risk of over
inating the tire.
• EXPLOSION HAZARD
• Never exceed tire pressure recommended by
tire manufacturer. Never mismatch tire size
and rim size.
• Avoid personal injury or death
DANGER
1. Never exceed these pressure limitations:
• Supply line pressure (from compressor) is 220 psi.
• Operating pressure (gauge on regulator) is 145 psi.
Bead setting pressure (gauge on hose) is the tire manufacturer’s maximum pressure as
stated on the sidewall of the tire
2. Activate air ination jets only when sealing bead.
To Next Page
Loading...
