Hunter XC User Manual

M A N U A L - A L L S T A T I O N S A L L
Seasonal Adjustment
Seasonal Adjust is used to make global run time changes without re-
programming the entire controller. To use the seasonal adjustment
feature:
1. Turn the dial to the SEASONAL
ADJUSTMENT position.
2. The display will now show a flashing
number
followed by a %, as well as the bar graph which
always remains on the d
isplay. Press the
button to adjust the percentage of the seasonal adjustment. Each
bar on the graph represents 10%. This feature can adjust the con-
troller from 10% to 150% of the original program.
To view the adjusted run times, simply turn the dial to the RUNTIMES
position, the displayed run time will be updated accordingly as the
seasonal adjustment is made.
Manually Run a Single Station 1
1. Turn dial to MANUAL– ONESTATION
position.
3.
Station run time will flash in the display. Use the
button to
move to the desired station. You may use the or button to
select the amount of time for a station to water.
4. Turn the dial clockwise to the RUNposition to run the station (only
the designated station will water, then the controller will return to
automatic mode with no change to the previously set program). Also
see
One Touch Start and Advance.
Manually Run All Stations
1.
Turn dial to
MAN
UAL
–
ALL
STATIONSposition.
3.
Select program A, B, or C by pressing the
button.
4. Station run time will flash in the display. Use the or button to select
the amount of time for a station to water if different from the run
time displayed.
5. Use the button to move to the next station.
6. Repeat steps 3 and 4 to customize each station.
7. Press thebutton until you reach the station at which you would like
watering to begin.
Turn the dial clockwise to the RUNposition (the controller will water
the entire program beginning with the station number last left in the
display, then return to the automatic mode with no change in the
previously set program).
One Touch Manual Start and Advance
You can also activate all stations to water without using the dial.
1. Hold down the button for 2 seconds.
2. This feature automatically defaults to program A. You can select
program B or C by pressing the button.
3. The station number will be flashing. Press the button to scroll
through the stations and use the or button to adjust station
run times. (If no buttons are pressed for a few seconds during step
2 or 3, the controller will automatically begin watering).
4. Press the button scroll to the station you wish to begin with.
After a 2 second pause, the program will begin. At any time during
the manual cycle, you can use the or buttons to navigate from
station to station manually.
NOTE:The controller should always be initially
programmed in the 100% position.
M A N U A L - O N E S T A T I O N 1

Hunter XC Specifications

General

Application	Residential
Station Output	24 VAC
Warranty	2 years
Voltage	24 VAC
Watering Programs	3
Display	LCD
Programs	3
Start Times Per Program	4
Indoor/Outdoor	Indoor
Backup Battery	9V (not included)
Mounting	Wall mount
Transformer Input	120V AC
Transformer Output	24V AC
Seasonal Adjustment	Yes
Enclosure Rating	Indoor/Outdoor (with proper enclosure)
Power Source	Transformer (included)
Rain Delay	Yes, up to 7 days