24
Operation
h. Battery Conditioner: * Press to select Battery Conditioner.
Press
to Confi rm.
Classification
Waveforms
Language
Battery conditioner
24/11/10 14:34
Battery Conditioner
(Do Not Disconnect from Mains)
If Battery Conditioner is selected when mains (line) power is not connected, the
following message is displayed:-
CONNECT Mains Power
Note: Battery conditioning will take approximately 8-10 hours to complete.
i. Demo Mode: Press
to select Demo Mode.
The Demo Mode shows results that have been pre-stored in the Ability. This
mode is useful at exhibitions without the need for a full test.
The printout is clearly marked ‘Demo Mode’ and shows pre-stored results and
artifi cial waveforms.
Waveforms
Language
Battery conditioner
Demo Mode
24/11/10 14:34
j. Cuff Leak Test: Refer to Troubleshooting Section.
k. Service Menu: Press
to select Service Menu. You will require a 4
digit access code to enter this function. Please see Service
Manual for further details.
Battery conditioner
Demo Mode
Cuff Leak Test
Service Menu
0
xxx
24/11/10 14:34
* Depending on model
To Next Page
Loading...
