Huntleigh dopplex ABIlity - 18. Electromagnetic Compatibility; Guidance and Manufacturers declaration - electromagnetic emissions

49
Electromagnetic Compatibility
18. Electromagnetic Compatibility
Make sure the environment in which dopplex Ability is installed is not subject to
strong sources of electromagnetic interference (e.g. radio transmitters, mobile
phones).
This equipment generates and uses radio frequency energy. If not installed
and used properly, in strict accordance with the manufacturer’s instructions,
it may cause or be subject to interference. Type-tested in a fully confi gured
system, complies with IEC60601-1-2, the standard intended to provide
reasonable protection against such interference. Whether the equipment causes
interference may be determined by turning the equipment off and on. If it does
cause or is affected by interference, one or more of the following measures may
correct the interference:
• Reorienting the equipment
• Relocating the equipment with respect to the source of interference
• Moving the equipment away from the device with which it is
interfering
• Plugging the equipment into a different outlet so that the devices are
on different branch circuits
WARNING: The use of accessories, transducers and cables other than
those specifi ed, with the exception of transducers and cables sold
by the manufacturer of the dopplex Ability as replacement parts for
internal components, may result in increased emissions or decreased
immunity of the dopplex Ability.
WARNING: The dopplex Ability should not be used adjacent to
or stacked with other equipment and that if adjacent or stacked
use is necessary, the dopplex Ability should be observed to verify
normal operation in the confi guration in which it will be used .
Guidance and Manufacturer’s declaration - electromagnetic emissions
The dopplex Ability is intended for use in the electromagnetic environment specifi ed below. The
customer or the user of the dopplex Ability should assure that it is used in such an environment.
Emissions Test Compliance Electromagnetic Environment - guidance
RF emissions
CISPR 11
Group 1
The dopplex Ability uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby electronic
equipment.
RF emissions
CISPR 11
Class B
The dopplex Ability is suitable for use in all
establishments, including domestic establishments and
those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic
purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fl uctuations /
fl icker emissions
IEC 61000-3-3
Complies