HUSABERG TE 250 EU - 10.14 Handlebar Position; 10.15 Adjusting the Handlebar Position

10 TUNING THE CHASSIS 42
10.12 Adjusting the compression damping of the fork
Info
The hydraulic compression damping determines the fork suspension behavior.
L00174-10
– Turn the white adjusting screw 1 all the way clockwise.
Info
Adjusting screw 1 is located at the upper end of the left fork leg.
The compression damping is located in the left fork leg COMP (white adjust-
ing screw). The rebound damping is located in the right fork leg REB (red
adjusting screw).
– Turn back counterclockwise by the number of clicks corresponding to the fork type.
Guideline
Compression damping (TE 125)
Comfort 24 clicks
Standard 22 clicks
Sport 16 clicks
Compression damping (TE 250/300)
Comfort 24 clicks
Standard 22 clicks
Sport 16 clicks
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
10.13 Adjusting the rebound damping of the fork
Info
The hydraulic rebound damping determines the fork suspension behavior.
L00317-10
– Turn the red adjusting screw 1 all the way clockwise.
Info
Adjusting screw 1 is located at the upper end of the right fork leg.
The compression damping is located in the left fork leg COMP (white adjust-
ing screw). The rebound damping is located in the right fork leg REB (red
adjusting screw).
– Turn back counterclockwise by the number of clicks corresponding to the fork type.
Guideline
Rebound damping (TE 125)
Comfort 23 clicks
Standard 21 clicks
Sport 21 clicks
Rebound damping (TE 250/300)
Comfort 20 clicks
Standard 18 clicks
Sport 18 clicks
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.