11 SERVICE WORK ON THE CHASSIS 65
11.45 Additionally securing the rubber grip
Preparatory work
– Check the rubber grip. ( p. 64)
401198-01
Main work
– Secure the rubber grip at two points using the securing wire.
Securing wire (54812016000)
Wire twister forceps (U6907854)
The twisted wire ends face away from the hands and are bent toward the rub-
ber grip.
11.46 Adjusting the basic position of the clutch lever
602520-10
(TE 125)
– Adjust the basic setting of the clutch lever to your hand size by turning adjust-
ing screw 1.
Info
Turn the adjusting screw counterclockwise to increase the distance
between the clutch lever and the handlebar.
Turn the adjusting screw clockwise to decrease the distance between
the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
L00165-11
(TE 250/300)
– Adjust the basic setting of the clutch lever to your hand size by turning adjust-
ing screw 1.
Info
Turn the adjusting screw counterclockwise to decrease the distance
between the clutch lever and the handlebar.
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
11.47 Checking/rectifying the fluid level of the hydraulic clutch
Info
The fluid level rises with increased wear of the clutch facing discs.
L00325-10
(TE 125)
– Move the clutch fluid reservoir mounted on the handlebar to a horizontal posi-
tion.
– Remove screws 1.
– Remove cover 2 with membrane 3.
– Check the fluid level.
Fluid level below container rim 4 mm (0.16 in)
» If the fluid level does not meet specifications:
– Correct the fluid level of the hydraulic clutch.
Hydraulic oil (15) ( p. 120)
– Position the cover with the membrane. Mount and tighten the screws.
To Next Page