11 SERVICE WORK ON THE CHASSIS 44
11.1 Raising the motorcycle with the lift stand
L00318-10
(TE 125)
Note
Danger of damage The parked vehicle may roll away or fall over.
– Always place the vehicle on a firm and even surface.
– Raise the motorcycle at the frame underneath the engine.
Lift stand (81229055100)
The wheels must no longer touch the ground.
– Secure the motorcycle against falling over.
L00315-10
(TE 250/300)
Note
Danger of damage The parked vehicle may roll away or fall over.
– Always place the vehicle on a firm and even surface.
– Raise the motorcycle at the frame underneath the engine.
Lift stand (81229055100)
The wheels must no longer touch the ground.
– Secure the motorcycle against falling over.
11.2 Removing the motorcycle from the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
– Always place the vehicle on a firm and even surface.
602502-10
– Remove the motorcycle from the lift stand.
– Remove the lift stand.
– To park the motorcycle, press side stand 1 to the ground with your foot and lean
the motorcycle on it.
Info
When you are riding, the side stand must be folded up and secured with the
rubber band.
11.3 Bleeding the fork legs
Preparatory work
– Raise the motorcycle with the lift stand. ( p. 44)
L00300-11
Main work
– Remove bleeder screws 1 briefly.
Any excess pressure escapes from the interior of the fork.
– Mount and tighten the bleeder screws.
Finishing work
– Remove the motorcycle from the lift stand. ( p. 44)
To Next Page
Loading...
