HUSABERG TE 250 EU - 11.21 Mounting the Seat; 11.22 Removing the Air Filter Box Lid; 11.23 Installing the Air Filter Box Lid; 11.24 Removing the Air Filter

11 SERVICE WORK ON THE CHASSIS 51
11.16 Removing the front fender
Preparatory work
– Switch off all power consumers and switch off the engine.
– Remove the headlight mask with the headlight. ( p. 84)
602507-10
Main work
– Remove screws 1.
– Take the brake line and wiring harness out of the brake line guide.
– Disconnect the connectors of the front turn signals.
L00210-11
– Remove screws 2. Take off the fender.
11.17 Installing the front fender
L00210-10
Main work
– Position the front fender. Mount and tighten screws 1.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
602507-11
– Position the brake line and wiring harness in the brake line guide.
– Connect the connectors of the front turn signals.
– Mount and tighten screws 2.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Finishing work
– Install the headlight mask with the headlight. ( p. 84)
11.18 Removing the shock absorber x
Preparatory work
– Raise the motorcycle with the lift stand. ( p. 44)