118 - English
7. MAINTENANCE AND SERVICE
Table 11: Service schedule 210 C
No. Check/Action For
information,
see:
Replaced parts
1.
Carefully clean the cable entries in
the body to ensure the rubber seals
sit correctly.
2.
Check the bearings, bearing cage
and hub in the skid plate. Clean
between the skid plate and blade
disc as well as between the blade
disc and the rubber bellows.
page 115
3.
Clean under the body: Inside and
outside of the drive wheels, around
the front wheel axles and the
chassis.
page 115
4.
Check the blades and screws. Operator’s
manual for
Automower
®
5.
Check the front wheel bearings. page 115
6.
Check the rubber bellows on the
cutting height adjustment. The
rubber bellows must not be
damaged.
page 115
7.
Check the charging strips and
contact strips.
page 90
8.
Check the movability and function
of the collision sensors, liftsensor
and the front body suspension.
page 39
9.
Check the rubber cap on the main
switch. The rubber cap must not be
damaged.
7.3 Sealing
the chassis
halves
page 116
10.
Check that the two halves of the
chassis have been sealed together
properly. Remove the body and
split the chassis halves. As needed,
lubricate the two halves of the
chassis (m/2003-2009) or replace
with rubber packing (m/2010-).
Check that the mower has the latest
edition and correct version of the
mower program.
Quick check
page 26 and
page 77
11.
Make an Auto test of all
components.
page 67
12.
Check on site that Charging works
correctly.
page 19
13.
Perform a battery check page 19
To Next Page
Loading...
