4. Disconnect the cable to the front loop sensor circuit
board.
5. Pull up the front loop sensor circuit board.
6. Install in opposite sequence.
6.15.6 To replace the front lift sensor
The front lift sensor circuit board must be replaced as a
unit. The magnet on the front edge below the body must
be installed correctly for the correct operation of the lift
sensor. If this is not the condition, the magnet holder,
which is part of the charging plate installation, must be
replaced.
1. Remove the top cover. Refer to
To remove and
install the top cover on page 19
.
2. Remove the body. Refer to
To remove and install
the body on page 19
.
3. Remove the upper chassis. Refer to
To remove and
install the upper chassis on page 20
.
CAUTION: Always disconnect the power
cable first to prevent current spikes that may
harm the circuit boards or the battery.
4. Disconnect the cable.
5. Push down the clip and remove the circuit board.
6. Install in opposite sequence.
6.15.7 To replace the rear loop sensor circuit board
1. Remove the top cover. Refer to
To remove and
install the top cover on page 19
.
2. Remove the body. Refer to
To remove and install
the body on page 19
.
3. Remove the upper chassis. Refer to
To remove and
install the upper chassis on page 20
.
CAUTION: Always disconnect the power
cable first to prevent current spikes that may
harm the circuit boards or the battery.
4. Disconnect the cable from the rear sensor circuit
board and the 2 cables connected to the battery.
5. Remove the cables from the cable holders on the
clamp.
6. Remove the 2 screws that holds the clamp.
28 - Repair instructions 1582 - 001 - 23.12.2020
To Next Page
Loading...
